![]() ![]() ![]() The short rear and turret are the largest downfalls of the leman russ design. Perhaps something were i can fit it over the existing leman russ rear, like your armored side skirts, or where i can cut off the rear with a bone saw and replace it with yours. Ditch one side of the exhaust pipes to give it an asymmetric look and i think you would have something much better. I would scrap the body, which is too curvaceous for a guard vehicle and concentrate on the rear engine deck extension you have there. However, i think a "total conversion" is the wrong way to go with this. I really appreciate the Russian aesthetic with the imperial guard you go after. Is it a BMP-3 turret? I converted all my chimeras to the Sciuridae Infantry Fighting Vehicles for my death korps. You have to press 3 (speed up) many times to reach top speed and then press 4 many times to return to 0.The turret looks wonderful. The tank moves by increasing or decreasing the speed of the rotors on the wheels underneath. The tank also has a gyro which you can use to wiggle it free. Hold W for speed boost when moving up hills or if you get stuck somewhere. 3 fixed gatling guns and 1 rocket launcher Rotor + Wheel "tank tread" movement system All controls are displayed in front of the driver's cockpit. It moves using wheels and rotors to imitate tank treads. This tank is modeled after the Leman Russ used by the Imperial Guard in the Warhammer 40K universe. Buildings shown in the video can be found here: ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |